Oil Pump Oil Seal; Removal; Installation - Isuzu 2000 Trooper Workshop Manual

6G–12
ENGINE LUBRICATION

Removal

1. Disconnect battery ground cable.
2. Drain engine oil.
3. Remove crankshaft pulley.
D Refer to removal procedure for Crankshaft Pulley in
this manual.
4. Remove timing belt.
D Refer to removal procedure for Timing Belt in this
manual.
5. Remove timing pulley from crankshaft.
6. Remove oil pump oil seal using a sealer puller.
NOTE: Take care not to damage sealing surfaces of oil
pump and crankshaft when removing oil seal.

Installation

1. Install oil pump oil seal, apply engine oil to oil seal lip,
then install oil seal using J-39202 installer.
2. Install timing pulley to crankshaft.
3. Install timing belt.
D Refer to installation procedure for Timing Belt in this
manual.
4. Install crankshaft pulley.
D Refer to installation procedure for Crankshaft
Pulley in this manual.
5. Refill engine oil until full level.

Oil Pump Oil Seal

015RS001