Removal; Installation - Isuzu 2000 Trooper Workshop Manual

7A–100
AUTOMATIC TRANSMISSION (4L30–E)

Removal

1. Remove the speedometer sensor (1).
2. Remove the plate (1).
3. Remove the speedometer driven gear bushing and
driven gear (1).
NOTE: Apply a reference mark to the driven gear bushing
before removal.
4. Remove rear companion flange (2), using the flange
companion holder J–8614–11 to remove the end nut.
5. Remove the rear companion flange.
NOTE: Use the universal puller to remove the rear
companion flange.

Installation

1. Install companion flange (2), using the companion
flange holder J–8614–11 to tighten the flange nuts to
the transfer case.
2. Tighten the new transfer flange nuts to the specified
torque.
Torque
Companion flange: 167 N·m (123 lb ft)
3. Use the punch J–39209 to stake the companion
flange nut (3) at two spots.
266RW001
266RW001
266RS001
266RW002