Installation - Isuzu 2000 Trooper Workshop Manual

27. Support the transmission with a transmission jack,
and hoist engine with a chain block.
28. Remove engine transmission fixing bolts (19).
29. Remove transmission assembly with transfer case
(4 4) / extension assembly (4 2) (20).
30. Remove transfer case / extension assembly from the
transmission assembly if necessary.
3. Support transfer case with a jack, and remove the
transmission jack.
4. Install flex plate torque converter bolts (6 pieces) by
turning crankshaft.
Torque: 54 N m (40 lb ft)
NOTE: Do not reuse the flex plate torque converter bolt.
AUTOMATIC TRANSMISSION (4L30–E)

Installation

1. Slowly raise transmission jack until front of the
transmission is aligned with rear of the engine, then
install transmission assembly.
2. Tighten engine transmission bolts, to the specified
torque.
7A–33
F07RY001
240RY003