Buell 2002 P3 Service Manual page 51

HOME
11 1
WARNING
To avoid accidental start-up of vehicle and possible per-
sonal injury, disconnect the battery cables before pro-
ceeding. Inadequate safety precautions could result in
death or serious injury.
5. Disconnect negative battery cable from battery.
6. Remove left footpeg support bracket. See
PEGS AND FOOTPEG SUPPORT
7. Remove three TORX screws with washers (1) from
clutch inspection cover (2). Remove clutch inspection
cover from primary cover.
CAUTION
Do not overfill the primary chaincase with lubricant.
Overfilling may cause rough clutch engagement, incom-
plete disengagement, clutch drag and/or difficulty in
finding neutral at engine idle.
8. See Figure 1-15. Add SPORT-TRANS FLUID (Part No.
98854-96 quart size; Part No. 98855-96 gallon size) as
required until fluid level is even with bottom of clutch dia-
phragm spring.
9. See Figure 1-14. Install clutch inspection cover using
three TORX screws with washers. Tighten in a crosswise
pattern to 7-9 ft-lbs (9.5-12.2 Nm).
10. Install footpeg support bracket. See
AND FOOTPEG SUPPORT
11. Connect negative battery cable to battery. Tighten fas-
tener to 60-96 in-lbs (6.8-10.9 Nm).
12. Install seat. See 2.28 SEAT.
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation, causing loss of control of vehi-
cle and death or serious injury.
1-18 2002 Buell P3: Maintenance
WARNING
2.21 FOOT-
BRACKETS.
2.21 FOOTPEGS
BRACKETS.
WARNING