Buell 2002 P3 Service Manual page 212

HOME
DISASSEMBLY
Crankcase Halves
1. See 3.5 CYLINDER HEAD. Remove cylinder head.
After removing cylinder, install plastic or rubber hose
over cylinder studs. Lifting or moving crankcase by
grasping studs will cause cylinder stud damage.
2. See 3.6 CYLINDER AND
piston.
3. See 3.13 OIL PUMP. Remove oil pump.
a0103x3x
7
6
1. Crankcase Set
2. Bottom Case T40 TORX Bolt – 5/16-18 X 3-1/2 in. long (5)
3. Washer 21/64 x 9/16 x 19 (14)
4. Hex Socket Head Screw – 3/8-16 X 4-1/2 in. long (1)
5. Spacer (1)
6. Washer - 3/8 I.D. X 13/16 O.D. (1)
7. Nyloc, Hex Locknut - 3/8-16
8. Hex Socket Head Screw – 5/16-18 X 2-1/2 in. long (9)
9. Rear Isolator
10. Screw (4)
11. Washer (4)
The next step requires using a press. Wear eye protec-
tion and make certain set-up is stable. The pressure
PISTON. Remove cylinder and
9
4
5
Figure 3-115. Crankcase Hardware
4. See 3.16 GEARCASE COVER AND CAM
Remove gearcase components.
5. See 6.2 PRIMARY CHAIN. Remove primary cover and
primary drive/clutch components.
6. See 5.7 STARTER. Remove starter motor.
7. See Figure 3-115. Remove screws and rear engine
mount bolts securing crankcase halves together.
8. Tap crankcase with plastic mallet to loosen and separate
the halves.
8 8 8
3 3 3
GEARS.
10
11
2
1
3
2
3
2
3
2
3
8
3
8
3
2
3
8 8 8
3 3 3
2002 Buell P3: Engine 3-65