Brakes Pads And Rotors - Buell 2002 P3 Service Manual

HOME
BRAKE PADS AND ROTORS
BRAKE PADS
11 1
WARNING
Always replace brake pads in complete sets for correct
brake operation. Never replace just one brake pad. Fail-
ure to install brake pads as a set could result in death or
serious injury.
Check front and rear brake pads for minimum thickness:
●
At the 1000 mile (1600 km) service interval.
●
At every scheduled service interval thereafter.
See Figure 1-9. See Figure 1-10.
damage or excessive wear. Replace both pads as a set if fric-
tion material of either pad is worn to 0.1 in. (1.5 mm) or less.
If this amount of wear occurs, wear grooves (2) will disappear
from friction material surface.
Replace rear brake pads and pins:
●
Every 15,000 miles (24,000 km)
NOTE
Always replace brake pads in pairs.
BRAKE ROTORS
11 1
WARNING
Do not allow brake fluid, bearing grease or other lubri-
cants to contact brake rotor or reduced braking ability
may occur, which could result in death or serious injury.
Check front and rear brake rotors for minimum thickness:
●
At the 1000 mile (1600 km) service interval.
●
At every scheduled service interval thereafter.
1. Measure rotor thickness. Replace if minimum thickness
is less than 0.18 in. (4.5 mm).
2. Check rotor surface. Replace if warped or badly scored.
3. The brake rotor must be within the following specifica-
tions. If the brake rotor is suspected of being damaged,
inspect rotor using the following measurements:
●
Lateral Movement: 0.01-0.02 in. (0.3-0.5 mm)
●
Radial Movement: 0.02 in. (0.45 mm)
●
Rotational Movement: 0.02 in. (0.39 mm)
1-14 2002 Buell P3: Maintenance
WARNING
Inspect brake pads for
WARNING
Metal Backing
a0031xox
Plate
Figure 1-9. Brake Pad - Side View
a0025xox
Figure 1-10. Measuring Rear Brake Outer Pad
1.7
Friction
Material
0.1 in. (1.5 mm)
Minimum
Brake Pad
Disc