Handlebar Switches - Buell 2002 P3 Service Manual

HOME

HANDLEBAR SWITCHES

REMOVAL
NOTE
The individual handlebar switches are not repairable.
Replace switch assembly upon switch failure.
Right Side
1. Detach throttle cables.
2. See Figure 7-74. Cut cable strap to access right handle-
bar switch connector [22] behind dash. Detach connec-
tor [22] from wiring harness.
3. Cut as many cable straps as necessary to access brake
switch connector [170]. Detach connector [170] from wir-
ing harness.
Left Side
1. Remove three screws from handlebar switch.
2. Separate switch housings and remove from handlebar.
3. See Figure 7-76. Cut cable strap(s) as necessary to
access left handlebar switch connector [24] and clutch
switch connector [95] behind dash. Detach connector
[24] from wiring harness.
4. Remove connector [95] from clutch switch.
INSTALLATION
Right Side
1. Attach throttle cables to hand control.
2. Position housings on right handlebar by engaging stud
on front housing with hole in handlebar. Fasten housings
with two screws. Tighten to 25-33 in-lbs (2.8-3.7 Nm).
3. See Figure 7-74. Route switch housing wiring harness
between front forks. Attach connector [170] and connec-
tor [22] to wiring harness. Fasten wiring harness behind
dash with new cable straps.
4. Adjust throttle cables. See
7-54 2002 Buell P3: Electrical
1.18 THROTTLE CABLES.
IGN POWER
IGN MODULE
FROM [3]
TO STARTER
ACC POWER
TO STOPLIGHT
Figure 7-74. Right Handlebar Switch Connection
7809
1. Ignition OFF
2. Ignition ON
3. Electric Starter Switch
Figure 7-75. Right Handlebar Switches
7.21
a0259x7x
Right Handlebar
Switch [22]
GY/O
BE 4
W/R W/BK
3
GN/BK W/BK
2
1 BK/R
Y/R
1
W/BK1 o
R/Y 2 R/Y
Brake Switch [170]
1
2
3