Bank Angle Sensor - Buell 2002 P3 Service Manual

HOME

BANK ANGLE SENSOR

REMOVAL
1. Remove seat. See 2.28
11 1
WARNING
To protect against shock and accidental start-up of vehi-
cle, disconnect the negative battery cable before proced-
ing. Inadequate safety precautions could result in death
or serious injury.
2. Disconnect negative battery cable from battery.
3. See Figure 7-11. Remove circuit breaker from mounting
bracket.
4. Remove allen head screw from mounting bracket while
holding locknut on Bank Angle Sensor side.
5. Remove Bank Angle Sensor from it's mounting location.
6. Disconnect connector [134] from Bank Angle Sensor.
7. Remove Bank Angle Sensor.
INSTALLATION
1. Connect connector [134] to new Bank Angle Sensor.
2. See Figure 7-12. Position Bank Angle Sensor in mount-
ing position on circuit breaker bracket mounting screw.
Make sure sensor locating post engages hole in trunk to
ensure proper alignment of sensor.
3. Install Bank Angle Sensor with allen screw and locknut.
Tighten screw to 25-27 in-lbs (2.8-3.1 Nm).
4. Install circuit breaker to circuit breaker mounting bracket.
5. Install negative battery cable to battery terminal. Tighten
fastener to 60-96 in-lbs (7-11 Nm).
6. Install seat. See 2.28 SEAT.
8261
Locknut
Connector
[134]
Figure 7-11. Bank Angle Sensor Removal
SEAT.
WARNING
Bank Angle
Sensor
8262
Circuit Breaker
Bracket
Locating
Post
Allen
Screw
25-27 in-lbs
(2.8-3.1 Nm)
Figure 7-12. Bank Angle Sensor Installation
2002 Buell P3: Electrical
7.5
7-13