Yamaha YQ50 Service Manual page 25

Q Seat lock
W Starter motor
E Ignition coil
R Battery
T Starter relay
Y Fuse housing
U Rear brake hose
I Fuel sender
O CDI unit
P Oil lever gauge
{ Main switch
} Rectifier/regulator
q Head light
w Water hose
e Water temperature sender
r Seat lock cable adjuster
A
C
G
CABLE ROUTING
A Set the seat lock adjuster so that there is a gap betwween 8 ~ 9 mm
at the seat lock aperture.
B Install the starter relay on the footrest board.
C Group the connections here.
D Turn the connectors towards.
E Puch the wiring inside.
F Pass the wiring harness through the footrest board.
G Turn the ground lead one turn around the starter motor leads.
H The water temperature sender lead must go straight to the wiring
harness.
I Put one drop of Loctite 542 on the tread before installing the water
temperature sender.
J Install the head light protector correctly.
K Pass the main switch lead between the rectifier/regulator and the
steering head pipe.
D E
2-10
B
F
H
SPEC
J
K
LT
I