Yamaha YQ50 Service Manual page 148

STEERING HEAD AND HANDLEBAR
354002
354011
CAUTION:
Hold the steering shaft until it is securely
attached.
4. Install :
• Washer Q
• Steering shaft lock nut W
NOTE:
Tighten the steering shaft lock nut with the ring
nut wrench. Set the torque wrench to the ring nut
wrench so that they form a right angle.
Ring nut wrench :
9079Q-02218
Steering shaft ring nut :
22.5 Nm (2.25 m.kg)
5. Install :
• Handlebar Q
• Bolt W (new)
• Nut E (new)
NOTE:
• Install the handlebar onto the steering shaft
notch.
• Install the wire harness, the throttle cable, the
speedometer cable and the rear brake cable.
6. Install :
• Throttle grip (complete)
• Master cylinder
• Brake hose (into the clip)
CAUTION:
• Before installing the handlebar, wipe off
any trace of oil from the inserted section of
the shaft with solvent.
• Insert the bolt from the left as shown.
Bolt (handlebar) :
60 Nm (6.0 m.kg)
7-26
CHAS