Network Configuration Table - Net2Phone Max 410 User Manual

Max 410/420/430 User's Guide – Chapter 5
menu. To modify any parameters on the page, simply
enter the desired values into the respective boxes.
NOTE:
DHCP users: If your LAN uses DHCP
addresses, you do not have to configure this
page. You may proceed directly to Account
Configuration, later in this chapter.
Static address users: Your IP address and
Subnet netmask are already present in the IP
Configuration table. Now you need to enter
the additional IP parameter information you
obtained from your LAN administrator. See
the IP Configuration section for more details.

Network Configuration Table

The Network Configuration table displays the doorman IP
addresses and ports, and the TCP/UDP start ports; the
Port numbers parameters must be changed to permit
access when a LAN's firewall permits only pre-assigned
TCP/UDP port numbers to be used.
Figure 13 – Network Configuration Table
The table includes the following fields:
Doorman
Primary IP
IP Address
o
Port
o
Secondary IP
IP Address
o
Port
o
35