Connecting The Max 410 To Your Lan; Connecting The Max 410 To A Dhcp Lan; Obtaining The Max 410'S Dhcp Ip Address - Net2Phone Max 410 Quick Start Manual

Net2Phone MAX 410 – Quick Start Guide

Connecting the MAX 410 to Your LAN

Connecting the MAX 410 to a DHCP LAN

The Net2Phone MAX 410's default configuration is for DHCP (Dynamic Host
Configuration Protocol). Therefore, if your LAN is using DHCP, the Net2Phone
MAX 410's IP address parameters were configured automatically when you
connected it to the LAN. In this case, you only need to know the IP address that
was assigned to the unit by the LAN before you can browse the MAX Web
Manager, MAX 410's Web-based configuration system.
If your LAN is using DHCP, configuring the Net2Phone MAX 410 will entail the
following steps:
1. Obtain the MAX 410's current IP address.
2. Log in to the MAX Web Manager.
3. Set the required configuration parameters via the MAX Web Manager.

Obtaining the MAX 410's DHCP IP address

When the Net2Phone MAX 410 is connected to a DHCP network, the current IP
address can be obtained via a PC connected to the MAX through its serial port,
using the HyperTerminal terminal-emulator application.
For this procedure you will need a standard serial cable (D-sub 9-pin, male-to-
female, straight-through connection) as shown in Figure 3, and a PC or Mac
running the HyperTerminal terminal-emulator program (or an equivalent), which is
included in Microsoft operating systems. It is usually found in the Programs menu,
under Accessories.
Figure 3
1. With the power to the Net2Phone MAX 410 turned OFF, connect the cable
from the unit's serial port to one of the PC's serial ports. Note which of the
PC's serial ports you are using.
2. Launch HyperTerminal and set up a new connection.
3. In the dialog box, specify the appropriate serial port, and set the serial
communication parameters as follows:
Baud rate
Parity
Character size
Stop Bit
Flow Control
Page 6
Connecting the MAX 410 to Your LAN
19200
None
8
1
None