Performing The Upgrade - Net2Phone Max 410 User Manual

Max 410/420/430 User's Guide – Chapter 5
ensure that after the upgrade, the faxes will be
transmitted using the T.38 fax protocol on the
Net2Phone network.
a. In the Web Manager, click the Account Config
link in the sidebar menu.
b. For each port that has a setting of Y in the FAX
Only field, click the N radio button. If no ports
are set to Y, you can proceed to the Performing
the Upgrade section below.
c. Click the Save Changes button at the bottom of
the page to save the settings.
Once you have completed this procedure, proceed to the
following section, Performing the Upgrade.

Performing the Upgrade

To upgrade the Max firmware:
1. Click the Download button to download the
executable file to the C:\Net2Phone\Upgrade folder.
2. Open your Windows Explorer and navigate to the
C:/net2phone/upgrade folder. Double-click the
max4x0up.exe file to begin the upgrade process.
3. You will be prompted for the following information:
a. User Name
b. Password
c. Max IP Address
4. Follow the remaining prompts to complete the
upgrade.
If you encounter any problems after you have upgraded
the Max, including faxing, calling, receiving calls, etc., re-
load the factory default settings and re-enter your
configuration settings.
To re-load the factory default settings and re-enter
your configuration settings:
1. In the Web Manager, click the Load Default Config
link in the sidebar menu.
67