Stud Installation - Chevrolet Trailblazer Service Manual

2. Finish installing the stud with the press.
NOTE: If a press is not available, use the following procedure:
A. Start the lug stud through the bore in the hub.
B. Place approximately four flat washers over the stud and thread the lug nut
to the stud.
C. Hold the hub/rotor while tightening the lugnut. Draw the stud into position.
D. Remove the lug nut and washers.
CAUTION
Ensure that the stud is fully seated.
E. Install the brake rotor.
F. Install the brake caliper.
G. Install the wheel and tire assembly.

Stud installation