Cruise Control
WARNING
To avoid personal injury and/or vehicle damage, refer to the service precautions at the
beginning of this section.
Cruise Control Switch
NOTE: The cruise control switch is integral to the turn signal/multifunction switch.
Instruments & Switches
Brake Light Switch
Removal & Installation
To Remove:
1. Remove the left sound insulator from the instrument panel (I/P).
2. Remove the pushrod retainer, stop lamp switch, and pushrod from the brake pedal
pin.
3. Disconnect the stop lamp switch connector.
To Install:
1. Connect the stop lamp switch connector.
2. Install the pushrod, stop lamp switch, and pushrod retainer onto the pedal pin.
3. Install the left sound insulator onto the instrument panel (I/P).