Adjustment; Range Selector Lever Cable; Range Selector Lever (A), Range Selector Lever Cable Bracket (B), Range Selector Lever Cable (C), Range Selector Lever Cable Retainer (D), Range Selector Lever Cable End (E) - Chevrolet Trailblazer Service Manual

Adjustment

NOTE: Only perform this procedure if the park/neutral position switch is not being removed
or replaced. If the park/neutral position switch is being removed or replaced, use the
removal and installation procedure.
1. Apply the parking brake.
2. Make sure the engine will only start with the transmission in the park or neutral
positions.
3. Shift the transmission to the neutral position.
4. Lift the vehicle.
5. Loosen the park/neutral position switch mounting bolts.
6. Put the vehicle in the neutral position and attempt to start the vehicle while turning
the park/neutral position switch.
7. When the engine starts, turn off the engine.
8. Torque the park/neutral position switch mounting bolts to 18 ft-lb (25 Nm).
9. Lower the vehicle.
10. Make sure the switch is operating properly. If the switch is not operating properly,
replace the switch.

Range Selector Lever Cable

To Remove:
1. Shift the transmission to the park position.
2. Lift the vehicle.
Range selector lever (A), Range selector lever cable
bracket (B), Range selector lever cable (C), Range selector
lever cable retainer (D), Range selector lever cable end (E)