10. Install the bolt and washer into the exhaust camshaft actuator. Torque the bolt to
18 lb-ft (25 Nm).
11. Use a J 36660-A torque/angle meter to turn the exhaust camshaft actuator bolt an
additional135 degrees.
12. Install the camshaft cover onto the cylinder head.
5.3L & 6.0L Engines
To Remove:
1. Remove the condenser from the radiator.
2. Remove the left and right cylinder heads and gaskets from the engine block.
3. Remove the valve lifters from the engine block.
4. Detach the camshaft sensor from the engine block.
5. Align the timing marks on the camshaft and crankshaft sprockets.
Camshaft sensor removal and installation