Mounting - Danfoss ECL Comfort 310 Installation Manual

Installation Guide

2.3 Mounting

2.3.1 Mounting the ECL Comfort controller
For easy access, you should mount the ECL Comfort controller near
the system. Select one of the following methods using the same
base part (code no. 087H3220 (ECL Comfort 210) or 087H3230 (ECL
Comfort 310):
• Mounting on a wall
• Mounting on a DIN rail (35 mm)
The ECL Comfort 210 can be mounted in the ECL Comfort 210 /
310 base part.
The ECL Comfort 310 can only be mounted in the ECL Comfort
310 base part.
Screws, PG cable glands and rawlplugs are not supplied.
Locking the ECL Comfort controller
In order to fasten the ECL Comfort controller to its base part, secure
the controller with the locking pin.
18 DEN-SMT/DK
ECL Comfort 310, application A376
To prevent injuries to persons or the controller, the controller has to
be securely locked into the base. For this purpose, press the locking
pin into the base until a click is heard and the controller no longer
can be removed from the base.
If the controller is not securely locked into the base part, there is a risk
that the controller during operation can unlock from the base and the
base with terminals (and also the 230 V a.c. connections) are exposed.
To prevent injuries to persons, always make sure that the controller
is securely locked into its base. If this is not the case, the controller
should not be operated!
The easy way to lock the controller to its base or unlock it is to use a
screw driver as lever.
VI.GU.B1.02
Danfoss District Energy