Table of Contents
Advertisement
Switch Specifications
Cabling Specifications
STP/UTP Category 5 wiring, 100 ohm impedance
100 meters between switch and network node
Electrical Specifications
Power:
UTP (RJ45) Connector
Figure 12 shows an RJ45 connector. For a 100Base-TX link between switches,
—any two Medium Attachment Units (MAUs)—you need a crossover cable. For
a connection to a Network Interface Controller (NIC), the cable is wired
straight through.
Low Last Bit-to-First Delay
For long packets:
For short packets:
24
Internal universal power supply with 100 to
120 VAC or 200 to 240 VAC, 50/60 Hz input.
Pin 1
Pin 8
Figure 12: RJ45 Connector
<30 µs
<18 µs
Advertisement
Table of Contents
