To Take Up Media In Loose Winding Mode - Oce CS6407 Basic Operation Manual

To take up media in LOOSE winding mode

CAUTION
- Apply the paper tube with the same length as the media width.
1
Scroller fl ange
Handle
Scroller fl ange
Knob screw
2
3
52
Océ 6407 Basic Operation Guide
Paper tube
Scroller shaft
Flange shaft fi xture
Take-up direction switch
OFF
Install the scroller shaft and scroller fl ange onto
the paper tube.
(1) Pass the scroller shaft through the roll spacer with
fi xtures at its both sides, scroller fl ange, and fl ange
shaft fi xture.
(2) Pass the scroller shaft through the paper tube.
(3) Insert the scroller fl anges into the paper tube's both
edges as far as they go.
(4) By rotating the handle fi x the scroller fl ange.
(5) Cover the scroller fl ange's convex part with the
fl ange shaft fi xture, and push the fl ange shaft fi xture
as far as it goes.
(6) Turn the knob screw to fi x the scroller shaft.
Set the take-up direction switch to OFF.
CAUTION
- If the Printer processing proceeds to the next step
with the take-up direction switch set to ON, your
hand may be caught as the scroller fl ange is not
secured.
Install the paper tube into the Printer's front side
(take-up side).