Oce CS6407 Basic Operation Manual page 42

10
11
12
13
14
Input the data in the RIP software.
15
42
Océ 6407 Basic Operation Guide
Press the
create a slack.
F E E D I N G M E D I A
Be sure to create a suffi cient slack so that you can
install the tension bar at the bottom of the tension bar
guide.
Open the tension bar guide's cover.
Place the tension bar at the bottom of the
tension bar guide.
Close the tension bar guide's cover.
Set the take-up direction switch according to
Take-up direction switch
the take-up direction.
Outer take-up
- OFF
OFF
Inner take-up
key to feed enough media to
When the tension bar does not reach the
tension bar guide's bottom
- When the tension bar does not reach the
tension bar guide's bottom, feed the media
with the operation panel's FEED menu. Confi rm
that tension bar was placed securely at the
tension bar guide's bottom.
When the excessive media slack is created
- If the media slack is secured excessively, the
take-up reel unit may keep winding the media
for more than the prescribed time, and a take-
up timeout error occurs. In such a case, turn off
the take-up direction switch, and then press the
switch again.