Table of Contents
Advertisement
Handling precautions
The precautions below are recommended to avoid damage to the Printer and its components.
Power supply
1. Install the Printer near the socket. To pull out the power plug in an emergency, the power socket must
be reached easily.
2. Do not share the power supply with the noise generating devices such as a motor.
3. Use the power supply voltage specifi ed on the nameplate.
4. Monthly turn off the Printer and check the following:
- The power plug is inserted into the socket securely.
- No dust is accumulated between the plug terminals and socket. When dust is found, clean the area
with a dry cloth.
Printer
1. Do not place anything on the top of the printer. Do not rest your elbows on the Printer. Especially be
careful not to block the printer's exhaust outlet shown by the fi gure below.
2. Do not apply shock or stress to the Printer.
3. During the print operation, do not open the front cover, nor set the pressure control knob to "Open."
Otherwise the printer operation is terminated.
4. Do not clean the cover's surface with benzene or paint thinner. This may damage the Printer's paint.
Clean the cover's smear with a soft cloth. If the cover is considerably smeared, wipe it off with a cloth
moistened with water-diluted neutral detergent. If it is not cleaned, the smear may aff ect the Printer's
surface painting.
5. Always use the SIIT-specifi ed attachments and options. The other products may degrade the image
quality, damage the Printer, and disable the maintenance.
6. Never touch the print head nozzles. They can be easily damaged or clogged.
Regular inspection and maintenance
Make sure you observe the appropriate maintenance guideline.
1. Clean the capping unit and wiper blade every day.
2. Everyday check visually the remaining wiper cleaning liquid is the specifi ed quantity or more.
3. Clean the print head every two months with the head cleaning kit (IP7-125).
4. If you leave the Printer off for more than 2 weeks, perform the service cleaning.
5. If, after the service cleaning, you leave the Printer for a long time and again you start the print operation
with the Printer, be sure to perform the head wash and charge the ink system.
Consumables
1. SIIT ink packs should be installed before the "Install By" date printed on the pack. The other ink may
damage the Printer, and the Printer repair fee is borne by you.
2. To ensure the quality, validated date is printed on the SIIT ink pack, storage liquid, and cleaning liquid.
Use the consumables before they expire. The expired consumables may cause deterioration in print
quality or the Printer's malfunction.
3. Put used ink packs into a plastic bag and dispose of them as industrial waste. Observe local regulations
12
Océ 6407 Basic Operation Guide
Advertisement
Table of Contents
