When Encountering A Problem; Check Your Problem - Oce CS6407 Basic Operation Manual

When encountering a problem

Check your problem

Before deciding that there is a serious problem with the Printer, check the following items.
Power is not turned on.
Items to be checked
Power cable connection
Power supply to the outlet
Power switch on/off
The paper guide is not heated even when the heater is turned ON.
Items to be checked
Printer status
Host computer RIP setting
Heater control menu
Power voltage
The printer fails to start or operate correctly.
Items to be checked
ERROR LED and LCD message
on the operation panel
The Printer cannot print.
Items to be checked
USB cable connection
ERROR LED and LCD message
on the operation panel.
Error LED OFF
Print head cleaning
72
Océ 6407 Basic Operation Guide
Check that the power cable is correctly plugged into the power outlet.
Supply power to the power outlet.
Turn on the power switch. See "Turn the Printer on." on page 31.
The paper guide is heated during
Printing or when the heater is turned on with the heater control menu. Be sure the
paper guide is heated by printing the nozzle print pattern or set the heater to ON.
See the Advanced Operation Guide.
The heater temperature can be set also by the RIP of the host computer. Check the
host computer setting.
Turn on the heater (afterheater/printheater/preheater) again, and then print nozzle
print pattern or forcibly set the heater to ON to check that the paper guide is heated.
See the Advanced Operation Guide.
Connect the Printer to 200 VAC power.
See "When an error message is displayed" on page 76.
Connect the USB cable correctly. See "To connect USB cable." on page 30.
See "When an error message is displayed" on page 76.
Print the nozzle adjustment pattern. See "Print the nozzle print pattern" on page 68.
(Confi rm that the RIP software "Test pattern" is printed.)
Clean the print head. See "Performing normal cleaning" on page 68.
Corrective measures
Corrective measures
Corrective measures
Corrective measures