Table of Contents
Advertisement
11
12
Supply side
13
(1)
With pressing the media
edge guard's your side part,
move each media edge
guard.
14
15
C H E C K E D G E G U A R D
✻ O K ?
36
Océ 6407 Basic Operation Guide
Feed back the media.
Feed back the media while pressing the center of the
media gently at the supply side.
Confi rm that the front media edge precedes the
closed front cover by approx. 30 cm.
Set the pressure to "Normal" by rotating the
pressure control knob counterclockwise.
Set the media edge guards.
(1) With pressing the media edge guard's your side part,
(2) Align each media edge guard's notch to the media
Check that the media edge guards are not under the
media or thick media is not caught by having been
inserted forcibly.
Notch
(2)
Align each media edge
guard's notch to the media
edge.
Close the front cover, and set the protection
bar.
Press the
30cm
Important!
- This step is important to set the media properly.
Point to be checked again
- Check that the media on the platen has no
wave or wrinkle.
move each media edge guard to the media edge.
edge.
CAUTION
- The print operation without media edge guards may
cause a media jam.
key.
Front cover
Advertisement
Table of Contents
