To Perform Double-Sided Printing - Oce CS6407 Basic Operation Manual

To perform double-sided printing

At double-sided printing
- The Printer does not contain the structure to feed media with correctly applying the media advance adjustment value.
So the Printer cannot correctly align the fi rst side image with the second side image.
For convenience of explanation on the double-sided printing below, the side printed fi rst is referred to as the
"First side" and the side printed next is referred to as the "Second side." The following procedure is described for
the case to print the fi rst side of the media, reinstall the media to the roll feed unit for each media roll that wound
the media, and then print the Second side of the media.
First side printing
1
S E L E C T M E D I A
R O L L / S H E E T : F A C E
2
54
Océ 6407 Basic Operation Guide
Media roll moves
Move
Load the media on the Printer.
For the procedure, see page 32.
At loading the media, on the operation panel select
[FACE] with the
Print the rougher side fi rst.
- With a single-sided-printing oriented banner,
the roughness grade is diff erent between
the front and rear surfaces. To print on such a
banner, print on the rougher side fi rst as a fi rst
side.
Load the media onto the take-up reel unit.
For the procedure to load the media onto the take-up
reel unit, see page 39.
Wind four full turns of the media on the
paper tube.
- Since a margin of approximately 2.5 m or more
is required for the second side printing, wind
about four full turns of media to the take-up
reel unit in advance.
Second side printing
or keys.