Table of Contents
Advertisement
(Media jam errors)
W A R N I N G !
C L E A R M E D I A J A M
W A R N I N G !
C L E A R M E D I A J A M
W A R N I N G !
C L E A R M E D I A J A M
(Media errors)
N O M E D I A L O A D E D
L O A D M E D I A
L O A D M E D I A
M E D I A S I Z E E R R O R
C H E C K M E D I A
M E D I A M I S A L I G N E D
R E L O A D M E D I A
78
Océ 6407 Basic Operation Guide
Meaning
An obstruction is left in the media feed path and the Printer
( 0 )
cannot feed the media normally.
Action
Set the pressure control knob to "Open", and open the front
cover.
If the media jam (0) error occurs repeatedly although there is no
media jam or no obstruction in the media feed path, contact your
service representative.
See "How to clear media jams" on page 75.
Meaning
An obstruction is left in the carriage path and the Printer cannot
( 1 )
drive the carriage normally.
Action
Set the pressure control knob to "Open", and open the front
cover.
If the media jam (0) error occurs repeatedly although there is no
media jam or no obstruction in the carriage path, contact your
service representative.
See "How to clear media jams" on page 75.
Meaning
The media is not detected correctly because:
( 2 )
- The roll media or cut-sheet media is wrongly selected or
- The applied cut-sheet media length does not match the
specifi ed one.
Action
Set the pressure control knob to "Open", and open the front
cover.
Besides, check that the settings are correct.
See "How to clear media jams" on page 75.
Meaning
No media is loaded on the Printer.
Action
When there is no media, install new media. If the fl ange is not
attached correctly, attach it correctly.
See "To load media on the Printer" on page 32.
Meaning
Media cannot be detected.
Action
Load media. See "To load media on the Printer" on page 32.
Meaning
Media of invalid width size (longer than 74 inches) was loaded.
Action
Load media of the specifi ed size.
See "To load media on the Printer" on page 32.
Meaning
The media skewed.
Action
Reinstall the media correctly. Ink may have been discharged on
the platen depending on the skew level. In that case, completely
remove the ink from the platen.
See "To load media on the Printer" on page 32.
Advertisement
Table of Contents
