Table of Contents
Advertisement
Bimini Top
A Bimini top is installed to provide you and your passengers with plenty of shade during your voyage.
The frame is made of anodized aluminum
when it is not in use. Both the Bimini top and Bimini boot are made of Sunbrella canvas.
The Bimini top should not be left up when transporting the boat on the highway. Therefore, whenever
transporting the boat on a trailer, you should remove the pins that hold the Bimini top upright and secure
the canvas top at the transom in the Bimini boot. Depending on the speed in which you are traveling, you
may want to secure the top further.
See the Service and Care section of this manual for cleaning recommendations.
Hard Top with Storage Box (Optional)
The anodized aluminum frame comes with a fiberglass hard
top and built in storage box. A set of 4 rod holders is
permanently mounted to the aft edge along the top of the
frame; providing you with additional rod holder capacity.
A storage box is installed below the fiberglass top and
includes the dome shaped courtesy light.
The photo shown at the right includes the optional spreader
lights and two of the speakers that are included with the
optional stereo.
See the Service and Care section of this manual for
cleaning recommendations for the anodized aluminum
frame and fiberglass hard top.
Note: Pro-Line installs mounting pads to the frame for additional support when outriggers
are factory installed. Before adding after market outriggers, we recommend that you
consult your Pro-Line dealer's Service Department or another qualified service
professional to add mounting pads to the hard top frame.
Hard Top with Storage Box & Outriggers (Optional)
When factory installed, this options includes the same frame and storage box as above. However, with
the installation of the outriggers, we have included mounting pads for additional support.
When this option is selected and factory installed, the outrigger installation includes a pair of outrigger
bases, poles and lines. The bases are constructed of anodized aluminum and are installed on the port
and starboard sides of the optional hard top. Turn the handle at the bottom of the outrigger base to rotate
o
the outriggers 90
(from the side to the aft end of the boat).
Rod Holder Storage
In addition to the rod holders installed on the optional hard top frame, the following rod holder storage is
available:
The Bimini top comes with a cover/boot to protect the top
38
Advertisement
Table of Contents
