Storage; Hardware; Cleats; Bow Rail - Pro-Line Boats 2007 24 Walk Owner's Manual

Storage

Your boat has lots of storage for your tackle and gear:

Shelf installed on the starboard aft cabin wall.

Storage compartment below the cabin sink

Beneath the V berth

Wet/dry storage compartment behind the port helm seat

Small storage box at the starboard helm seat

Hardware

Cleats

Your boat is equipped with 3 standard and 4 pop-up cleats. They are installed to provide areas to permit
you to tie off the boat at dockside, tie off to another boat that is anchored, secure bumpers/fenders,
and/or tie off the anchor (when dropped) to prevent the line from pulling on the optional windlass, etc.
You should never use the cleats for towing another boat or skier.

Bow Rail

The bow rail is constructed of stainless steel. The railing, which is through bolted to the gunwale, is
provided for safety. Never use the bow rail to tie off to anything heavier than a bumper/fender. Do not
use the bow rail for anchoring, or to tie off to the dock or another boat. Do not use the bow rail to tow
another boat or skier. Never stand on the bow rail or use it as leverage when pulling up an anchor, a fish
or any other objects. Do not use the bow rail to tie off and/or secure a large catch, etc.

Grab Rails

Two stainless steel grab rails have been installed to provide safe boarding and navigation on the boat.
They are located at the port transom ladder and next to the port helm seat as you step down into the
cabin.
Bow Pulpit with Anchor Roller and Rope Locker Storage
An aluminum anchor roller has been installed at the bow pulpit. If you have selected the optional
windlass, the anchor line will be secured inside the anchor locker and then routed through the windlass
and anchor roller. The anchor (not included as standard equipment) can be held on the line beneath the
bow pulpit. This allows you to move about the bow area safely without tripping over the line or anchor.

Dive Platform - Integrated w/Ladder

An integrated Euro style dive platform is built into the fiberglass construction of the
deck and hull and includes a stainless steel dive ladder on the port side of the
transom.
As an option, on single engine installations only, a 2
on the starboard side of the dive platform.
includes an additional grab rail. With the engines tilted down, passengers can move
easily through the transom door and across the large dive platform.

Gunwale Trim / Rubrail

A white rigid vinyl gunwale trim with a stainless steel insert is installed at the juncture of the deck and hull.
This durable trim provides a nice clean look and serves as somewhat of a cushion when you are docking,
coming along side another vessel, etc.
See the Service and Care section of this manual for cleaning recommendations.
nd
dive ladder may be installed
When factory installed, this option
35