Table of Contents
Advertisement
Gunwale Trim / Rubrail
A white rigid vinyl gunwale trim with a stainless steel insert is installed at the juncture of the deck and hull. This
durable trim provides a nice clean look and serves as somewhat of a cushion when you are docking, coming
along side another vessel, etc.
See the Service and Care section of this manual for cleaning recommendations.
Drain Plug
Before launching the boat, always make sure that the drain plug has been installed in the fitting on the transom at
the keel. If your boat is being transported, remove the drain plug once the boat is secured on the trailer so that
any excess water can be drained via the fitting. Never remove the drain plug when the boat is sitting static in the
water.
If you live in an area where it snows and you are storing your boat on a lift during the winter, make sure that you
remove the drain plug. When the snow melts, if the float switch for the bilge pump happens to fail, it could flood
the bilge and damage electrical components in the bilge.
Cockpit / Deck Drains
There are three (3) cockpit/deck drains in the aft area of the cockpit that allow excess
water in the cockpit to drain overboard via thru hulls on each side of the boat. To
ensure that there is no blockage in any of the hoses connected to the drains, it is
recommended that you occasionally run water through each of the cockpit drains and
visually inspect the thru hulls to verify that water flows freely and that there is no
blockage. To trouble shoot, check the hoses for leaks and make certain that all hose
connections are secure.
Anchor Roller with Cleat (Optional)
As an option, you may have selected to install the aluminum anchor roller and cleat at the bow pulpit. The anchor
line can be secured inside the anchor locker and is then routed through the anchor roller. The anchor (not
included as standard equipment) is held on the line beneath the anchor roller. This allows you to move about the
bow area safely without tripping over the line or anchor.
Dive Platform – Integrated with Ladder
The ladder on the dive platform allows you easy boarding and lets you easily stow away the step.
Seating
Your boat has cushioned captain seats at the helm and seating in the bow area. In
addition, there is the availability of a wide variety of seating options at the helm that
includes:
Bow cushion with bolsters for the casting deck
Back to back – Port and/or starboard
Folding rear bench seat
Lounge seat – Port and/or starboard
Note: Captain seats come with seat cushions (cushions not shown in
photo)
Bimini Top (Optional)
The frame is made of anodized aluminum and the Bimini canvas top is made of high quality Sunbrella canvas.
Please see the Service and Care section of this manual for cleaning and care recommendations.
26
Advertisement
Table of Contents
