Camera Setup - Revo R16DVR3 User Manual

User's Manual
NOTE: You can access a remote DVR and monitor live video images using the media players like VLC Player
supporting the RTSP service. Start the media player on your local PC and enter "rtsp://ID:Password@IP address:
RTSP port number/trackID='channel number'", or start Internet Explorer on your Blackberry or other mobile
devices and enter "http://IP address:REVO Remote port number/".
NOTE: The RTSP service might not be supported, depending on the type of media player.
Mail Settings (NETWORK  Mail Tab)
 Use SSL/TLS: Check the box when sending an e-mail via an SMTP server requiring SSL (Secure Sockets Layer)
authentication.
 Authentication: Select the button if the SMTP server needs authentication,
and set up the Authentication by selecting the Use box and entering the user
ID and password.
NOTE: This product includes software developed by the OpenSSL Project
for use in the OpenSSL Toolkit (http://www.openssl.org/).
 Sender/Recipient: Enter the sender's/recipient's e-mail address. The e-mail address must include the "@" character
to be a valid address.

CAMERA SETUP

Camera Settings
 PTZ Port Setup...: Select the button and set up the PTZ device you are connecting to
the DVR. Check the Enable RS485 box and set the port's setting according to the PTZ
device manufacturer's instructions.
18
 Enable: The DVR can be set up to send an e-mail when an
event occurs. Selecting the box enables the Mail function.
You will only be able to change the settings if Mail is enabled.
 SMTP Server: Set the SMTP server IP address or domain
name obtained from your system administrator.
NOTE: You will need to get the IP address or domain
name of the SMTP server from your network
administrator. You can use the domain name instead
of IP address if you set up the DNS server during Network
setup.
 Port: Set the SMTP server port number obtained from
your system administrator.
 No.: Selecting the box toggles all or each camera On and
Off.
 Title: Change the name of all or each camera.
 PTZ Model: Select the PTZ device you wish to configure
from the list.
 ID: Set the PTZ ID of each camera.