Event Setup - Revo R16DVR3 User Manual

EVENT SETUP

Motion Event Settings (EVENT  Motion Tab)
 Sensitivity: Set the DVR's sensitivity to motion for Daytime and Nighttime independently
from 1 (the least sensitive) to 5 (the most sensitive).
 Zone: Define the area of the image where you want to detect motion; e.g., a doorway. The Motion Detection Zone
screen is laid over the video from the selected camera. You can set up motion zones one block at a time in groups
of 16 individual block groups. A block group is positioned within the image area using the arrow buttons on the
remote control, and individual blocks within the block groups are selected or cleared using the camera buttons on
the remote control. Pressing the
screen. Each item in the menu has the following functions:
NOTE: You can select the block groups to be selected or cleared by using the mouse. Place the mouse pointer
where you want to start the line. Hold down the left mouse button and drag the pointer to where you want to
end of the line. Release the mouse button and a group of blocks appears along the line you drew. You can
draw lines around shapes by repeating this process.
 Min. Blocks: Set the minimum number of detection blocks that must be activated to
trigger a motion alarm for Daytime and Nighttime independently.
 Actions: Set the actions the DVR will take whenever motion is detected on the
selected camera. Motion event can sound the external alarm or DVR's internal
buzzer, notify a number of different devices, and/or move PTZ cameras to preset
positions.
Alarm Out. – Select the alarm-out signals (Alarm-Out and Beep) to be associated
with the camera.
Notify – Select Mail if you want to send an e-mail to the address set during NETWORK – Mail setup.
PTZ – Select the preset position for each PTZ camera, where you want PTZ cameras to move to.
 No.: Your DVR has built-in motion detection. Selecting
the box turns the motion detection On and Off for each
camera.
button on the remote control or clicking the right mouse button displays the menu
16 Channel Digital Video Recorder
Select/Select All – Activates highlighted blocks or all blocks
to detect motion.
Clear/Clear All – Deactivates highlighted blocks so that
they will not detect motion.
Reverse/Reverse All – Activates inactive highlighted blocks
or all inactive blocks and deactivates active highlighted
blocks or all active blocks.
OK – Accepts changes and closes Zone setup.
Cancel – Exits Zone setup without saving changes.
21