Revo R16DVR3 User Manual page 23

 Use UPnP: Check the box when using the UPnP (Universal Plug and Play) service. When using the UPnP service,
port forwarding from the NAT (Network Address Translation) device to the DVR will be enabled automatically via
UPnP service. This function will be used especially when accessing to a port on a private IP address. Checking the
Status box displays the port numbers forwarded from the NAT device via UPnP service.
NOTE: For the UPnP service to work, the NAT device should support the UPnP Port Forwarding function and
the function should be set to enabled.
NOTE: You cannot change the port settings when Use UPnP is On.
DVRNS Settings (NETWORK  DVRNS Tab)
 Use DVR Name Service: Checking the box when using the DVR Name Service function. You will only be able
to change the settings if Use DVR Name Service is enabled.
 DVRNS Server: Enter the IP address or domain name of the DVRNS server.
NOTE: You will need to get the IP address or domain name of the DVRNS server from your network administrator.
You can use the domain name instead of IP address if you set up the DNS server during Network setup.
 Port: Set the port number of the DVRNS server.
 Use NAT: Check the box when using NAT. When using a NAT (Network Address Translation) device such as a
router, refer to the NAT manufacturer's instructions for the proper network settings.
 DVR Name: Enter the DVR name to be registered on the DVRNS server. Check whether or not the name you
entered is available by selecting the Check button.
NOTE: The DVR name you entered should be checked by selecting the Check button, otherwise the DVRNS
changes will not be saved. When no name is entered or a name is already registered on the DVRNS server,
an error message displays.
 Help Desk: Selecting the Save button registers the DVR on the DVRNS server. Proper DVRNS settings will cause
the help desk information of the DVRNS server to display.
RTSP Settings (NETWORK  RTSP Tab)
NOTE: The DVRNS (DVR Name Service) allows you to
connect to the DVR, via internet, with the dynamic IP
address or the domain name. To make this feature easy,
you can name your DVR (example: TomStore05) and
connect using the DVR name instead of the IP address.
To use the DVRNS feature, you will need to have your DVR
registered through DVRNS with the settings matched
between your DVR and the DVRNS server. Any changes
to the DVRNS server might cause improper operation.
NOTE: When Network settings have been changed, set up
the DVRNS after saving your Network changes by selecting
the Save button.
 Enable RTSP: Selecting the box enables the RTSP
(Real-Time Streaming Protocol) service. You will be able
to change the settings if Enable RTPS is enabled.
 RTSP Port: Set the port number of the RTSP server
obtained from your system administrator.
 RTP Port: Set the Start Port and End Port numbers of the
RTP server obtained from your system administrator.
 Use Mobile: Selecting the box when using Blackberry or
other mobile devices.
16 Channel Digital Video Recorder
17