Appendix D Menu Tree - GRAPHTEC CE-3000-120 AP User Manual

Appendix D Menu Tree

(ENTER) key
S E L E C T U S E R 4.27 User-specified Settings
C O M M A N D 4.28 Setting the Format of Data to be Received
R S - 2 3 2 C 4.29 Interface Settings
4.30 Setting the PAGE LENGTH
P A G E L E N G T H
S E P A R A T O R 4.31 Setting the SEPARATOR Function
T I M E O U T 4.32 Setting the TIMEOUT Function
4.2 Clearing the Buffer Memory
C L E A R B U F F E R
F E E D & C U T 4.3 Setting the FEED & CUT function
B L A D E W A R E S E T U P 4.4 Blade Wear Detection (When Blade Wear Setup is On)
P E N U P / D O W N 4.5 Raising and Lowering the Pen
C U T L I N E P A T . 4.6 Selecting the Type of Perforated Line.
4.7 Setting TANGENTIAL Mode
T A N G E N T I A L
I N I T . B 4.8 Selecting the Blade Tip's Initial Position
P E N U P S P E E D 4.9 Setting the PEN UP SPEED
I N I T I A L F E E D 4.10 Specifying the INITIAL FEED Length
4.11 Setting AUTO PRE-FEED
A U T O P R E F E E D
(ENTER) key
A D V A N C E D F U N C .
S E T U P M E N U
T E S T 4.33 TEST Mode
D I S T A N C E A D J U S T 4.12 Distance Adjustment
A X I S A L I G N M E N T 4.13 Aligning the Coordinate Axes
P L O T A R E A 4.14 Setting the Cutting/Plotting Area
4.15 Expanding the Cutting/Plotting Area
E X P A N D
R O T A T E 4.16 Rotating the Coordinate Axes
S O R T 4.17 Sorting Settings
S P A C E R E A R 4.18 Specifying the SPACE REAR Distance
4.19 Setting the OFFSET FORCE (Initial Cutting Force)
O F F S E T F O R C E
I N I T . D O W N F O R C E 4.20 Setting the Initial Down Force
S T E P P A S S 4.21 Setting the STEP PASS
O F F S E T A N G L E 4.22 Setting the OFFSET ANGLE
F _ C U T 4.23 Setting the F_CUT Function
4.24 Setting the LENGTH UNIT
L E N G T H U N I T
P E N 1 / 2 A D J 4.25 Setting the Distance Compensation Between the Pens
4.26 Cutting/Plotting Using the Buffer Memory (COPY Function)
C O P Y
Appendix
A-5