Setting The - GRAPHTEC CE-3000-120 AP User Manual

4.30 Setting the PAGE LENGTH
This function sets the length of each page when long-axis cutting or plotting is performed using a roll
medium. This should be set for long-axis cutting or plotting exceeding 5 m in length. The default setting is
"5000 mm."
(1) Press the
C L E A R B U F F E R
(2) Press the
F E E D & C U T
B L A D E W A R E S E T U P
P E N U P / D O W N (3) Press the
C U T L I N E P A T .
T A N G E N T I A L
I N I T . B
(4) Press the
P E N U P S P E E D
I N I T I A L F E E D
A U T O P R E F E E D
A D V A N C E D F U N C .
S E T U P M E N U
(5) Press the
T E S T
(PAUSE) key to switch to PAUSE mode.
(NEXT) or
S E T U P M E N U
(ENTER) key, and then press the
until the following menu is displayed.
P A G E L E N G T H
(ENTER) key to display the page-length menu.
L = 0 5 0 0 0 m m
Use the or key to move the cursor to the digit to be changed. Use the
and keys to increase or decrease the setting, and then press the
(ENTER) key to confirm. To cancel, press the
(PAUSE) key to cancel PAUSE mode.
CHECKPOINT
• This setting is retained in the memory even when the power is turned off.
• The cutting plotter's distance precision is guaranteed for page-feed lengths of up to 3
meters. Long-axis cutting over 5 meters is possible for lengths of up to 50 meters in
the feeding direction.
• In the case of long-axis cutting, be particularly careful when loading the meduim. If the
meduim is loaded at even a slight angle, it may come loose from the rollers that hold it
in place.
• For long-axis cutting using roll media, pull out the length of the medium to be used, or
use the pre-feed operation (see "4.10 Specifying the INITIAL FEED Length" and "4.11
Setting AUTO PRE-FEED").
(PREV.) key until the following menu is displayed.
(NEXT) or
Function Settings and Operations
(NEXT) or
(PREV.) key
(PREV.) key.
4-35