Table of Contents
Advertisement
Fitting the transport locking de-
vice on driving end (KS)
Note:
Attach plate (6) only to the upper part of the openings.
1.
Secure plates (6) with screws (4) and washers (5) at the bores on both sides of the flywheel housing
and tighten to the specified tightening torque.
Name
Screw
2.
Screw nut (2) onto screw (1) up to the end of the thread.
3.
The long end of holder (3) must face downwards. Push holder (3) through the plate opening (6).
Note:
The holder (3) must lock the flywheel only, not the ring gear.
4.
Install screw (1) into the bore of holder (3) until holder (3) is locked in position.
Note:
Screw (1) must be tightened alternately on both sides of the flywheel housing.
5.
Tighten screw (1) with torque wrench to the specified tightening torque.
Name
Screw
6.
Screw on nut (2) of both screw (1) at plates (6) and secure.
Removing the transport locking
device from driving end (KS)
1.
Release locknut (2) on both sides of the fly-
wheel housing, remove screw (1) and take
off the lock (3).
2.
Unscrew screw (4) and remove together
with washer (5) and plate (6).
3.
Store the removed parts of the transport
locking device together with this documen-
tation carefully for possible reuse.
Size
Type
M16
Tightening torque
Size
Type
M10
Tightening torque
Lubricant
Value/Standard
(Engine oil)
250 Nm +25 Nm
Lubricant
Value/Standard
(Engine oil)
30 Nm +3 Nm
MS150029/02E 2013-03 | Safety | 9
Hide quick links:
Advertisement
Table of Contents
