Table of Contents
Advertisement
7.21.6 EMU 7 – Removal and installation
Preconditions
☑ Engine is stopped and starting disabled.
NOTICE
Wrong engine governor installed.
Engine damage!
• When reassembling an engine, make sure that the governor with the data record for the given
engine is installed.
Removing ECU with EMU from
engine
1.
Note or mark assignment of cables and
connectors.
2.
Remove all screws (2).
3.
Undo latches (3) of the connectors.
4.
Disconnect all connectors.
5.
Remove screws (1).
6.
Remove ECU (1) with EMU (4).
Removing EMU
1.
Unscrew screws on base of EMU (4).
2.
Remove EMU (4) from ECU (1).
Installing EMU
1.
Place EMU (4) on ECU (1).
2.
Screw in and tighten screws on base of EMU (4).
Installing ECU with EMU on engine
1.
Install in reverse order. Ensure correct assignment of connectors and sockets in so doing.
2.
Check resilient mount before installing.
Result:
Replace resilient mount if porous or defective.
168 | Task Description | MS150029/02E 2013-03
Hide quick links:
Advertisement
Table of Contents
