MTU 12 V 4000 G73 Operating Instructions Manual page 167

7.21.5 ECU 7 engine governor – Removal and installation
Preconditions
☑ Engine is stopped and starting disabled.
NOTICE
Wrong engine governor installed.
Engine damage!
• When reassembling an engine, make sure that the governor with the data record for the given
engine is installed.
Removing engine governor from
engine
1. Note or mark assignment of cables and
connectors.
2. Remove all screws (2).
3. Undo latches (3) of the connectors.
4. Disconnect all connectors.
5. Remove screws (1).
6. Take off engine governor.
Installing engine governor on engine
1. Install in reverse order. Ensure correct assignment of connectors and sockets in so doing.
2. Check resilient mount before installing.
Result: Replace resilient mount if porous or defective.
MS150029/02E 2013-03 | Task Description | 167