Do The Procedures Below For Either Single Port Or Double Ports - Ricoh B202 Service Manual

G3 INTERFACE UNIT

Do the procedures below for either single port or double ports.

For Single Port Installation
[A]
[B] [G]
[F]
[E]
[D] [C]
B713I002.WMF
1. Install the CCU drive board [A] on the spacers ( x 4).
2. Install the flat cable [B] to the CCU drive board.
NOTE: Make sure that the blue side of the flat cable faces up.
3. Connect the G3 board [C] to the interface board [D].
4. Remove the "LINE 2" cover [E].
5. Attach the interface board and G3 board to the spacers ( x 6).
6. Connect the cable [F] to the interface board and CCU drive board.
7. Attach the clamp [G] and bind the cable [F] with this clamp.
B712 8 SM