Sd Card Appli Move - Ricoh B202 Service Manual

5.7 SD CARD APPLI MOVE

5.7.1 OVERVIEW
The service program "SD Card Appli Move" (SP5-873) lets you to copy application
programs from one SD card to another SD card.
Slot 1 and Slot 2 are used to store application programs. Slot 3 is for maintenance
work only. You cannot run application programs from Slot 3. However you can
move application programs from Slot 3 to either Slot 1 or Slot 2. Do the following
procedure it you want to move an application procedure from Slot 3:
1) Choose a SD card with enough space.
2) Enter SP5873 "SD Card Appli Move". Then move the application from the
SD Card in Slot 3 to the Slot you want.
NOTE: Do steps 1-2 again if you want to move another application program.
3) Exit the SP mode
Use high caution when you do the AD Card Appli Move procedure:
1. The data necessary for authentication is transferred with the application
program from an SD card to another SD card. Authentication fails if you try to
use the SD card after you copy the application program from one card to
another card.
2. Do not use the SD card if it has been used by the user on the computer.
Normal operation is not guaranteed when such an SD card is used.
3. Keep the SD card in a safe place after you copy the application program from
one card to another card. This is done for the following reasons:
1) The SD card can be the only proof that the user is licensed to use the
application program.
2) You may need to check the SD card and its data to solve a problem in the
future.
4. You cannot copy PostScript data to another SD card. You have to copy other
data to the same SD card that stores PostScript data.
SM
SD CARD APPLI MOVE
5-161 B202/B178/B180