Installing The Multi-Bin Output Tray - Ricoh B202 Service Manual

OPTIONAL UNIT

Installing the Multi-Bin Output Tray

NOTE: Install the duplex unit before you install the multi-bin output tray.
1. Open the left cover [A] of the duplex
unit.
2. Install the ground plate [B] behind the
magnet.
3. Install the ground plate [C] on the rear
of the left cover.
4. Attach the ground plate to the top
cover. Then align the bottom edges of
the plate [D] and cover [E].
5. Attach the discharge brushes [F][G] to
the upper edges of the paper exits.
Make sure that the ends of the brushes
[H][I] touch the ground plates [C][D]
respectively.
NOTE: Make sure the brushes do not
stop paper at the exits.
6. Install the front [A] and rear [B] tray
holders on the top cover ( x 2 for
each).
7. Install the upper [C] and lower [D]
trays.
8. Turn the main switch on. Then select
the SP mode menu, SP6–901–1. Then
change the multi-bin output tray
setting.
NOTE: The multi-bin output tray is not
automatically recognized by the
printer mainframe. You cannot
use the multi-bin output tray until you have changed this SP mode setting.
B202/B178/B180
[D]
[E]
[C]
[H]
[I]
[B]
1-38
[B]
B178I523.WMF
[A]
B178I524.WMF
B178I525.WMF
[D]
[A]
[F]
[G]
[C]
SM