I-Fax Switches - Ricoh B202 Service Manual

4.2.2 I-FAX SWITCHES

I-fax Switch 00
No FUNCTION
Original Width of TX
Attachment File
0 A4
1 B4
2 A3
3-6 Reserved
7 Not used
I-fax Switch 01
No FUNCTION
Original Line Resolution of TX
Attachment File
0 200x100 Standard
1 200x200 Detail
2 200x400 Fine
3 Reserved
4 400 x 400 Super Fine
5-6 Reserved
0: Not selected, 1: Selected
NOTE:
If more than one of these three bits is set to "1", the higher resolution has priority.
For example, if both Bit 3 and Bit 2 are set to "1" then the resolution is set for
"Reserve (300 x 300)" (Bit 3).
SM
COMMENTS
This setting sets the maximum size of the original
that the destination can receive. (Bits 3~7 are
reserved for future use or not used.)
0: Off, 1: On
NOTE: If more than one of these three bits is set to
"1", the larger size has priority. For example,
if both Bit 2 and Bit 1 are set to "1" then the
maximum size is "A3" (Bit 2).
When mail is sent, there is no negotiation with the
receiving machine at the destination, so the sending
machine cannot make a selection for the receiving
capabilities (original width setting) of the receiving
machine. The original width selected with this switch
is used as the RX machine's original width setting,
and the original is reduced to this size before
sending. The default is A4.
If the width selected with this switch is higher than
the receiving machine can accept, the machine
detects this and this causes an error.
COMMENTS
This setting sets the maximum resolution of the
original that the destination can receive.
51
BIT SWITCHES
SP No. 1-102-001
SP No. 1-102-002
B712