Log Set Installation - kozy heat 911 Installation Manual

#932-500A LOG SET INSTALLATION
ATTENTION If converting to LP (propane) gas, do so now before installing log set. Follow instructions included with conversion kit.
NOTE Log numbers are located on bottom of each log. Refer to following instructions and illustrations for proper placement.
Do not place logs directly over burner port holes. Improper log placement may affect flame appearance and cause excessive
CAUTION
soot to build up on logs and glass.
AG
Align notches on bottom of BI log with brackets in burner cover. Set down into position.
Position AD, AG, HB & AJ logs onto burner cover, pressing down onto pins.
Figure 18a
Figure 18b
Use a steel or stiff bristle nylon brush to distribute Rock Wool Embers onto logs and burner.
BI
M
Align hole in bottom of right M log to knob on HB log.
Position remaining M log and C log as shown above.
AD
AJ
C
M
18
HB