Toshiba e-Studio 2040c Imaging Manual page 93

2. Copier-specific Adjustments
(4) Enter adjustment mode [05]. Change the values for codes [7960], [7961], [7965], [7966], [7970], [7971],
[7975], [7976] and [7980] to [7983] to adjust the density level of each color.
Color to
Original mode
adjust
Text/Photo
Y
(Yellow)
User custom
Text/Photo
M
(Magenta)
User custom
Text/Photo
C
(Cyan)
User custom
Text/Photo
K
(Black)
User custom
* Set the value in increments of approximately 10, while checking the copy image until the optimum value
is obtained.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set
the subcode for the area to be adjusted.
Subcode
0
1
2
Precautions after the completion of the adjustment
The adjustment may possibly cause a dark-colored area, such as in a photo, to become blurred on the copy. Also,
it may also cause offset failure, grained images and degradation in gradation. Therefore, carefully perform the
adjustment, while checking the copy image.
e-STUDIO2040C/2540C/3040C/3540C/4540C
[05] code
05-7960
Text 05-7961
05-7980
05-7965
Text 05-7966
05-7981
05-7970
Text 05-7971
05-7982
05-7975
Text 05-7976
05-7983
Area where the density is adjusted
Low-density area
Medium-density area
High-density area
2 - 52
Recommended
Subcode
value
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2 Set a value larger
than 128.
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
© 2011 TOSHIBA TEC CORPORATION All rights reserved
Acceptable
Default
value range
0 to 255 128