Toshiba e-Studio 2040c Imaging Manual page 63

2. Copier-specific Adjustments
(4) Enter adjustment mode [05]. Change the values for codes [7960 to 7979] to adjust the color density.
Color to
Original mode [05] code Subcode Recommended value
adjust
Text/Photo
Text
Y
Printed image
(Yellow)
Photo
Map
Text/Photo
Text
M
Printed image
(Magenta)
Photo
Map
Text/Photo
Text
C
Printed image
(Cyan)
Photo
Map
Text/Photo
Text
K
Printed image
(Black)
Photo
Map
* Set the value in increments of approximately 10, while checking the copy image until the optimum value is
obtained.
* The value for the code corresponding to the original mode (Text/Photo, Text, or Printed image) will affect
the copy image quality in the Full color mode and the Auto color mode.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set the
subcode for the area to be adjusted. The density of the highlighted area will vary, if the low- or medium-
density area is mainly adjusted. Setting "2" for subcode allows you to adjust the high-density area. But it
will not affect the highlighted area. Therefore, never change the value for the high-density area.
Subcode
0
1
Precautions after the completion of the adjustment
The adjustment may possibly provide an excessively dark background. Therefore, carefully perform the
adjustment, while checking the copy image.
Remarks
Enter a value within the recommended value range mentioned in the procedures. Otherwise, it may cause a loss
in MFP performance, including degradation in the image quality and a reduction in the life of the consumables.
e-STUDIO2040C/2540C/3040C/3540C/4540C
05-7960 0/1
05-7961 0/1
05-7962 0/1
05-7963 0/1
05-7964 0/1
05-7965 0/1
05-7966 0/1
05-7967 0/1
05-7968 0/1
05-7969 0/1
05-7970 0/1
05-7971 0/1
05-7972 0/1
05-7973 0/1
05-7974 0/1
05-7975 0/1
05-7976 0/1
05-7977 0/1
05-7978 0/1
05-7979 0/1
Area where the density is adjusted
Low-density area
Medium-density area
2 - 22
Acceptable
value range
Set a value larger than
128 to increase the
density.
Set a value smaller than
128 to decrease the
density.
© 2011 TOSHIBA TEC CORPORATION All rights reserved
Default
0 to 255 128