Toshiba e-Studio 2040c Imaging Manual page 38

(5) Finely adjust the rotating speed of the registration motor, in accordance with a pattern for the out-of-
registration colors.
• Use steps (a) to (b) to perform the adjustment.
(a) Enter adjustment mode [05]. Select code [4523]. Finely adjust the rotating speed of the registration
motor.
• Adjust the values in accordance with a pattern for the out-of-registration colors as shown in the
table below.
Pattern for
out-of-
registration
colors
Pattern A
Pattern B
(b) After performing registration control, print out the test print pattern to check whether the misaligned
colors have been improved.
* For further information regarding the adjustment procedures, refer to procedures (3) and (4).
* Repeatedly use procedures (3) to (5) as necessary, to select a proper value.
<Hint> When subcode "0" is adjusted for code 05-4523, the correlation between the paper feeding speed
and rotating speed of the transfer belt will be corrected in every paper mode. However, when
colors are misaligned on an image printed in the thick paper mode after the adjustment for
subcode "0", adjust subcode "3" (during deceleration in the thick paper mode).
* For subcode "3," use the steps and recommended values for subcode "0."
* Paper for printing a test print pattern will only be fed from the drawer. Load the desired
number of sheets of thick paper in the drawer, in order to print the test print pattern on thick
paper.
* Adjust subcode "0" and then subcode "3," in order to adjust only misaligned colors in the thick
paper mode.
e-STUDIO2040C/2540C/3040C/3540C/4540C
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
[05] Sub-
Recommended value
code code
e-STUDIO2040C: 131 to 135
e-STUDIO2540C / 3040C / 3540C /
(Set a value smaller than default)
05-4523 0
e-STUDIO2040C: 137 to 141
e-STUDIO2540C / 3040C / 3540C /
(Set a value larger than default)
1 - 25
4540C : 129 to 133
4540C : 135 to 139
© 2011 TOSHIBA TEC CORPORATION All rights reserved
Acceptab
le value Default
range
e-STUDIO2040C:
136
0 to 255
e-STUDIO2540C
/ 3040C / 3540C /
4540C: 134