Toshiba e-Studio 2040c Imaging Manual page 27

1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
(b) Enter the setting mode [08]. Change the value of the codes [5293] to [5296] to adjust fusing
temperature in the recycled paper mode. (In this step fusing temperature is adjusted to print the
high-density area of the image most clearly.)
Adjustment
Normal temp /
Normal temp /
Center
heater
Low temp /
Low temp /
Normal temp /
Normal temp /
Side
heater
Low temp /
Low temp /
Normal temp /
Normal temp /
Sub
heater
Low temp /
Low temp /
Normal temp /
Normal temp /
Pressure
roller
Low temp /
Low temp /
• After adjusting the fusing temperature, perform automatic calibration.
* Refer to step (2) in "1.1 To Obtain a Darker Image".
<Hint> The smaller the setting value is, the lower the fusing temperature becomes. It is usually
recommended that the set value be decreased in order to suppress roughness on the high-density
area of the image. Adjust the value while checking the image carefully because if the value is
too small, insufficient fusing may occur.
Since temperatures on the long side of the paper cannot be kept in a proper balance, the same
value must be set for the [08] codes [5293] and [5294] unless otherwise required so.
After setting the value, print and check the image quality.
If further image quality adjustment is necessary, go to step (3).
e-STUDIO2040C/2540C/3040C/3540C/4540C
Paper [08]
type code
Black
Color Recycled
08-5293
paper
Black
Color
Black
Recycled
Color
08-5294
paper
Black
Color
Black
Recycled
Color
08-5295
paper
Black
Color
Black
Recycled
Color
08-5296
paper
Black
Color
Recomm
Subco
ended
de
value
0
3 to 8
1
2
3 to 8
3
0
3 to 8
1
2
3 to 8
3
0
3 to 8
1
2
3 to 8
3
0
2 to 6
1
2
2 to 6
3
© 2011 TOSHIBA TEC CORPORATION All rights reserved
1 - 14
Accept
able
Default
value
range
• e-STUDIO4540C:
0 to 16 5
• Others: 4
• e-STUDIO4540C:
0 to 16 7
• Others: 6
• e-STUDIO4540C:
0 to 16 5
• Others: 4
• e-STUDIO4540C:
0 to 16 7
• Others: 6
0 to 16 5
0 to 16 7
0 to 16 4
0 to 16 4