Toshiba e-Studio 2040c Imaging Manual page 199

3. Printer-specific Adjustments
PCL6 PS3 XPS
(1) Enter adjustment mode [05]. Change the value to adjust the image density in the toner save mode.
* The [05] code to use varies, depending on whether to adjust the image quality on Full Color or Twin Color
printing or on Black and White printing. Use either of the procedures below corresponding to the type of
original to print.
To adjust the image quality in Full Color or Twin Color printing
("Auto," "Color" or "Twin Color" is selected from among the "Color" options on the PCL6 or PS3 or XPS
printer driver. "Auto," "Color" or "Twin Color" is selected from among the "Color Type" options on
Macintosh.)
* The "Color" options are available in the "Basic" tab on the PCL6, PS3 and XPS printer drivers. The
"Color Type" options are available in the "Color Settings 1" menu in the print dialog box on Macintosh.
(a) Enter adjustment mode [05]. Change the value for code [8160] to adjust the upper limit of the image
density in the toner save mode.
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
PDL [05] code
PS3 05-8160
PCL6 05-8160
XPS 05-8160
* Set the value in increments of approximately 10, while checking the printouts until the optimum value
is obtained.
e-STUDIO2040C/2540C/3040C/3540C/4540C
Mac
Subcode Recommended value
Set a value smaller than 176 to
0
decrease the density.
1
Set a value larger than 176 to
2
increase the density.
3 - 72
Acceptable value
range
0 to 255
© 2011 TOSHIBA TEC CORPORATION All rights reserved
Default
176