Toshiba e-Studio 2040c Imaging Manual page 299

6. Printer-specific Adjustments (GA-1211)
From touch panel
When the ColorCal calibration is operated from the touch panel of the MFP, the following operations are
available:
• Selecting Calibration Sets
The Calibration Set of only one selected media type is valid for the calibration. Note that the operation starts
without a warning even if any Calibration Set is not assigned to a profile, however, it will not be applied to
the result. Especially, the Calibration Set for Thick2/3/4 that is not set by default must be assigned to a
profile by referring to procedures in "6.1.3 To Calibrate for Thick 2/3/4".
• Selecting an input (feeding) tray (e.g. LTR, bypass tray)
• Printing the Measurement Page (only one page)
• Scanning the Measurement Page with KODAK (or TIFFEN) Grayscale
• Printing the built-in Comparison Page (or skip)
* Even if you usually perform calibration only from the touch panel, perform the scanner calibration using
Calibrator at least one time at the initial stage so that the accuracy of ColorCal will be enhanced.
From Calibrator
When the ColorCal calibration is operated from Calibrator, many detailed settings are available as follows:
• Figuring out the last status of the previous calibration without printing the Configuration Page
• Specifying Calibration Sets
• Setting "Apply to all calibration sets"
• Specifying the combinations of multiple profiles and the desired Calibration Set
• Specifying the number of the Measurement Pages
• Specifying the Patch Page number of the Measurement Page (only for ColorCal)
• Calibrating the scanner
• Printing sample images before applying calibration results
• Printing sample images of a user file before applying calibration results
(The file "Calib.ps" must be created. Refer to "6.3 To Print in Desired Color Balance".
• Saving and downloading calibration data
• Comparing the printer engine gamma before applying calibration results and the target gamma
• Displaying the read values at calibration
• Comparing the printer engine gamma after applying calibration results and the target gamma
e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
6 - 6