Install Decorative Glass Murano 1800Dgm - Valor 1800JN Installation & Owner's Manual

QUALIFIED
INSTALLER

Install Decorative Glass Murano 1800DGM

Material required
• Murano Glass Fire Kit, which contains:
◊ 2 bags of clear fi reglass
◊ Left and right glass platforms
◊ 4 sheet metal runners
◊ 2 sheet metal middle tabs
• Small container to distribute fi reglass (not supplied)
Installation
Carefully unpack the kit.
1. Install the 4 sheet metal runners around the burner.
The open end of the runners are oriented towards
the middle and the tabs at the bottom. The tabs fi t
into the slots of the burner supports.
2. Install the sheet metal middle tabs in front and
behind the burner between the runners as indicated.
The fl ange is oriented towards the burner. The small
tabs at the bottom fi t into the slots of the middle
supports under the burner.
pilot
runner
burner
runner
3. Place the left and right glass platforms, smooth side
on top, around the burner on top of the runners and
tabs. The left platform has a notch that goes around
the pilot. Push the platforms as far back as possible
to maximize the air gap behind the burner.
Installed glass platforms
46
Installation
runner
tab
runner
4. Fill a small container with approximately 3 cups
(750 ml) of fi reglass.
5. Carefully spread the fi reglass on the surface of
burner patting it gently with your hand to form a
single layer to the approximate level of the top edge
of the fl ange around the burner. Do not pour too
much to avoid blocking the burner ports.
6. Some fi reglass may be added on the platform to
cover the edge of the burner.
NOTE: Ensure the area within the pilot shield is
clear of fi reglass.
IMPORTANT: Approved for use only with the fi reglass
provided with your Valor fi replace or the tempered
crushed fi reglass brands American Fireglass™ or
fi regear. The use of any other fi reglass products may
void your fi replace warranty.
WARNING
!
CHOKING HAZARD! Ensure that the fi replace
area is clear of fi reglass particles as these could
be ingested by small children. Vacuum area after
installation.
Pilot shield