Using Remote Control Handset Wall Holder; Locating Lighting, Operation And Rating Information Card; Servicing Your Fireplace; Fireplace Control Devices - Valor 1800JN Installation & Owner's Manual

2. Disconnect the snap connector
from the battery holder. Do
not pull the connector by the
wire!
3. Replace the batteries with 4
AA alkaline batteries orienting
them as indicated inside the
holder.
4. Reconnect the snap connector
to the battery holder.
5. Put the battery holder back in its place beside the
wall switch and snap it in place.
Using Remote Control
Handset Wall Holder
Your fi replace equipment includes
a wall holder to store the handset.
If it hasn't be installed, refer to the
instructions further on in this manual
for the installation.
Locating Lighting, Operation and Rating
Information Card
WARNING
!
DO NOT ATTEMPT TO TOUCH THE DATA CARD
WHILE THE FIREPLACE IS STILL HOT! Let the
fi replace cool fi rst before touching it.
The Lighting, Operation and Rating information is
located on a card at the right hand side of the fi replace
opening. The card is attached under the plinth.
The data card is located behind the front panel below
the window at the right-hand side.
To access the card, remove the barrier screen, side
doors and the plinth. Grab the rolled card and pull it out
of its clip. There is important information on both sides
of the card.
Owner's Information
Disconnect
connector
Window
Data
card

Servicing Your Fireplace

If any attention is required for your appliance, contact
your supplier quoting the model number. It will be
helpful if the appliance's serial number can also
be quoted. This number is on the rating plate. The
replacement parts are shown at the end of this manual.
Please always quote the part number and description
when requesting spare parts.

Fireplace Control Devices

There are two ways to control your fi replace.
1. Thermostatic Remote
Control;
2. Wall Switch.
The Thermostatic Remote
Control can be programmed
to function automatically—
see pages 11–15.
The Wall Switch can be used to turn on, off and to
increase or decrease the fl ame height—see page 16.
How to Turn Your Fireplace OFF
(including pilot)
Familiarize yourself with each of these methods before
operating your fi replace.
Press and hold the OFF button for a second (either on
the handset or the wall switch).
Remote control handset
If the fl ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
As well, familiarize yourself with the gas shut-off valve
location in your house. As indicated below, the gas is
running when the handle is parallel with the pipe. The
gas is off when the handle is perpendicular with the pipe.
ON: parallel to pipe
OWNER'S
INFORMATION
Thermostatic
Wall Switch
Remote Control
Wall Switch
OFF:
perpendicular
to pipe
9